{
  "version": "1.0.0",
  "notes": {
    "zh-CN": [
      "新增首次启动驱动准备引导，按系统检查并安装所需驱动，完成后进入主界面。",
      "新增关节标定、舵机 ID 修改和基础运动控制。",
      "新增 App 代码及系统更新入口；优化安装步骤和下载目录选择。",
      "自动更新成功后弹出更新内容，同一版本关闭后不再重复显示。",
      "新增问题排查：USB 自动检查系统与日志，局域网检查 App 反馈，内置 30 条排查说明并支持导出报告。",
      "新增局域网标定和运动控制；配网、App 启停、舵机 ID 修改和系统维护仍使用 USB。",
      "优化烧录后的 USB 识别与失败提示；语言入口改为地球图标；修正镜像下载完成后的页面定位。"
    ],
    "en": [
      "Added first-launch driver setup: check and install the required drivers for your system before entering the main screen.",
      "Added joint calibration, servo ID editing, and basic motion controls.",
      "Added app code and system updates; improved installation steps and download folder selection.",
      "Show release notes after a successful automatic update, once per version.",
      "Added troubleshooting: USB system/log checks, LAN app feedback checks, 30 troubleshooting notes and report export.",
      "Added LAN calibration and motion control. Wi-Fi setup, app start/stop, servo ID changes and system maintenance continue to use USB.",
      "Improved USB detection and failure messages after flashing; replaced the language selector with a globe icon; corrected page positioning after image downloads."
    ]
  },
  "review": {
    "approved": true,
    "contentSha256": "602dcdb0211a4ca4b4903f3debd8819da310fe4a96f2106b7504a2ec42480904",
    "confirmedBy": "user",
    "confirmedOn": "2026-10-26",
    "confirmation": "用户要求15版本改为1.0发布，并确认修改首次启动驱动准备更新说明；其余六条保持原确认内容。"
  }
}